Difference between revisions of "optiPoint 410/420 CorNet IP (HFA) to SIP migration"
The Wiki of Unify contains information on clients and devices, communications systems and unified communications. - Unify GmbH & Co. KG is a Trademark Licensee of Siemens AG.
(→Connect the phone to LAN) |
(→Subscriber number is prompted) |
||
Line 17: | Line 17: | ||
# Enter your fully qualified subscriber number. | # Enter your fully qualified subscriber number. | ||
− | # Confirm < | + | # Confirm <tt>Save Changes</tt> with the [[Image:opk-ok.png]] key.<br>The display shows:<br><tt>Administration</tt><br><tt>01=Configuration?</tt> |
Continue with [[#Detect the phone's IP address|Detect the phone's IP address]]. | Continue with [[#Detect the phone's IP address|Detect the phone's IP address]]. | ||
Revision as of 07:17, 26 July 2011
This migration procedure is for upgrading an optiPoint 410/420 CorNet IP phone V5.1.2x to SIP V6.0.56 and later. The procedure can be performed on a per phone basis (local admin menu or via WBM) - described on this page - or, starting with V7R4.1.0, via DLS.
Contents
Precondition
Please check your hardware revision against the data in the product release note (section "Hardware revisions supported") as not all HW revisions shipped with CorNet IP protocol will support SIP. See also optiPoint HW compatibility.
Connect the phone to LAN
- Connect the optiPoint CorNet IP phone to the LAN (DHCP=on is default). The assumption is that DHCP is available in your local area network. The phone will reboot.
- Depending on the version of the CorNet IP application installed
- either you may be prompted to enter the subscriber number, then continue with Subscriber number is prompted
- or you may not be prompted, then continue with Subscriber number is not prompted.
Fully qualified subscriber number
Subscriber number is prompted
- Enter your fully qualified subscriber number.
- Confirm Save Changes with the key.
The display shows:
Administration
01=Configuration?
Continue with Detect the phone's IP address.
Subscriber number is not prompted
If you have not been prompted for the subscriber number, the display will show Invalide GW Adress
or No subscriber number
.
- Press the key.
The display shows:Administration
01=Configuration?
- Continue with Detect the phone's IP address.
Detect the phone's IP address
- Press the key. The display shows:
Enter admin password
_
- Enter the admin password (default: .
The display shows:Config:
01=Network?
- Press the key and the key to select
02=Terminal IP addr.?
. - You may read the IP address and use this to switch over to the WBM by using a web browser (Microsoft Internet Explorer recommended).
Continue with Download new firmware.
Download new firmware
- In the Web browser's URL row type in
https://Phone-IP-Address
, e.g.https://192.168.1.2
orhttp://Phone-IP-Address:8085
, e.g.http://192.168.1.2:8085
.
- Enter the
Administration
menu (default password: 123456). - Select the
Upload/Download
section. - Select
Download application
. - Start a standard FTP server (e.g. 3Com Daemon), and fill out the relevant FTP data, refer to the screenshot below.
- Continue with Restore factory settings.
Restore factory settings
After successful restart of the application, it is recommended to perform a factory reset.
-> How to optiPoint 410/420 S factory reset