Talk:CallBridge Collection
The Wiki of Unify contains information on clients and devices, communications systems and unified communications. - Unify GmbH & Co. KG is a Trademark Licensee of Siemens AG.
Revision as of 19:58, 16 November 2006 by Davide.poletto (talk | contribs)
Hello, we could add a table like the one below, valid for the three types of CallBridge providers:
Currently supported phones
Workpoint | Operating mode | Connection | CallBridge TA | CallBridge TU | CallBridge IP | Note |
---|---|---|---|---|---|---|
optiSet E basic | Up0/E | V.24 | Yes | No | No | 1 |
optiSet E advance | Up0/E | V.24 | Yes | No | No | 1 |
optiSet E advance plus | Up0/E | V.24 | Yes | No | No | 2 |
optiSet E conference | Up0/E | V.24 | Yes | No | No | 2 |
optiSet E memory | Up0/E | V.24 | Yes | No | No | 2 |
optiPoint 500 basic | Up0/E | USB | No | Yes | No | 1 |
optiPoint 500 standard | Up0/E | USB | No | Yes | No | 2 |
optiPoint 500 standard SL (USA only) | Up0/E | USB | No | Yes | No | 2 |
optiPoint 500 advance | Up0/E | USB | No | Yes | No | 2 |
optiPoint 600 office | Up0/E | USB | No | Yes | No | 2 |
optiPoint 410 entry | HFA | IP | No | No | Yes | 1 |
optiPoint 410 economy | HFA | IP | No | No | Yes | 1 |
optiPoint 410 economy plus | HFA | IP | No | No | Yes | 1 |
optiPoint 410 standard | HFA | IP | No | No | Yes | 2 |
optiPoint 410 advance | HFA | IP | No | No | Yes | 2 |
- Note 1: These workpoints have the On-Hook Dialing feature, but not Handsfree. This means that user can only answer an incoming call or establish a connection to the remote station by manually lifting the handset.
- Note 2: These workpoints have both On-Hook Dialing and Handsfree features as well as a loudspeaker key. This means that user can make a call without needing to operate the phone manually.
--Kimera 11:23, 16 November 2006 (CET)
- Have a look on the Phone supporting matrix. And the optiPoint SIP phones - are they also applicable? ... and I think, we should put in another row with optiPoint 600 as HFA device. --Horemu 16:01, 16 November 2006 (CET)
- Hi, added optiPoint 600 office HFA (CorNet IP), it was left behind ;-).
- About CallBridge Collection V2.0 and optiPoint 410/420 S support it should be possible (Obiouvsly only via an IP TSP application, in that case the CallBridge IP or the HiPath TAPI 120 V1.0).
- Moreover on the optiPoint 410/420 S (Either available via optiGuide or phone's WBM), I'm referring to V6.0, there are two CTI-related parameter likes:
- * Auto Answer CTI
- * Auto Reconnect CTI
- those let the phone interworking with a (Not well defined) CTI application running on a PC on the same LAN.
- Hi, added optiPoint 600 office HFA (CorNet IP), it was left behind ;-).