optiPoint 410/420 CorNet IP (HFA) to SIP migration
The Wiki of Unify contains information on clients and devices, communications systems and unified communications. - Unify GmbH & Co. KG is a Trademark Licensee of Siemens AG.
This migration procedure is for upgrading an optiPoint 410/420 CorNet IP phone V5.1.2x to SIP V6.0.56 and later.
Contents
Connect the phone to LAN
- Connect the optiPoint CorNet IP phone to the LAN (
DHCP=on
is default). The assumption is that DHCP is available in your local area network. The phone will reboot. - Depending on the version of the CorNet IP application installed
- either you may be prompted to enter the Fully qualified subscriber number, then continue with Subscriber number prompted
- or you may not be prompted to enter the Fully qualified subscriber number, then continue with Subscriber number is not prompted.
Subscriber number is prompted
- Enter some digits like ???
- Confirm
Save Changes
with the key. - The display will show:
Administration
01=Configuration?
- Press the key.
Continue with Detect the phone's IP address.
Subscriber number is not prompted
If you have not been prompted for the subscriber number, the display will show:
Invalide GW Adress
or No suscriber number
Continue with Detect the phone's IP address.
Detect the phone's IP address
The display will show:Enter admin password
_
- Press key pad for digits , which is the factory default password.
- The display will show:
Config:
01=Network?
- Press the key and the key to select
02=Terminal IP addr.?
. - You may read the IP address and use this to switch over to the WBM by using a web browser (Microsoft Internet Explorer recommended).
Continue with Download new firmware.
Download new firmware
- In the Web browser's URL row type in
http://Phone-IP-Address:8085
, e.g.http://192.168.1.2:8085
. - Enter the Administration menu (default password: 123456).
- Select the
Upload/Download
section. - Select
Download application
. - Start a standard FTP server (e.g. 3Com Daemon), and fill out the relevant FTP data, refer to the screenshot below.
- Continue with Restore factory settings.
Restore factory settings
After successful restart of the application, it is recommended to perform a factory reset.
- Select Restore factory setting in the WBM.
- Enter the factory reset password: 124816.
The phone will reboot and start with the updated firmware version.
This has to be removed here later: Quick Guide Migrating CorNet-IP to SIP