|
|
| (One intermediate revision by one other user not shown) |
| Line 1: |
Line 1: |
| − | Hello!
| + | hipath 1120 |
| − | | |
| − | Could we add a '''section''' like this one:
| |
| − | | |
| − | ----
| |
| − | | |
| − | === [[Wireless]] ===
| |
| − | * [[optiPoint WL2 professional family (CorNet-IP/SIP) Surveying Mode]]
| |
| − | | |
| − | ----
| |
| − | | |
| − | and then write down a little ''How To'' about optiPoint WL2 professional (Either CorNet-IP or SIP versions) Surveying Mode operation ?
| |
| − | | |
| − | Actually, on the wiki, there is only a link to the "HiPath Wireless Controller, Access Points and Convergence Software, Site Survey Guide V3.0" PDF manual in which the optiPoint WL2 professional Surveying Mode is considered on 7.1.1.1 "Survey Approach about Surveying Mode" section.
| |
| − | | |
| − | A simple ''How To'' would be useful for HiPath 2000 V1.0 with HiPath Wireless AP2630 (Or AP2640) deployments.
| |
| − | | |
| − | I used here "Wireless" as section title because there is not a generic ''optiPoint WL2 professional'' wiki homepage ''regardless'' of which protocol its uses: CorNet-IP and SIP versions are still kept separate (That's quite logical too) but not so practical when an ''How To'' article could be related to both.
| |
| − | | |
| − | --[[User:Davide.poletto|Kimera]] 11:01, 15 November 2006 (CET)
| |
