Difference between revisions of "optiPoint 410/420 S factory reset"
The Wiki of Unify contains information on clients and devices, communications systems and unified communications. - Unify GmbH & Co. KG is a Trademark Licensee of Siemens AG.
(→optiPoint 410/420 S (with display)) |
|||
Line 12: | Line 12: | ||
* Disconnect phone from [[LAN]]. | * Disconnect phone from [[LAN]]. | ||
* Lift handset. | * Lift handset. | ||
− | * Type in reset code [[ | + | * Type in reset code [[Image:opk-minus.png]] [[Image:opk-plus.png]] [[Image:opk-ast.png]] [[Image:opk-3.png]]. |
− | * Type in reset password [[ | + | * Type in reset password [[Image:opk-1.png]] [[Image:opk-2.png]] [[Image:opk-4.png]] [[Image:opk-8.png]] [[Image:opk-1.png]] [[Image:opk-6.png]]. |
* Replace handset. | * Replace handset. | ||
* Connect phone to [[LAN]]. | * Connect phone to [[LAN]]. | ||
== optiPoint 410/420 entry S == | == optiPoint 410/420 entry S == |
Revision as of 06:14, 4 September 2006
The reset to factory defaults at optiPoint 410/420 S phones can be done in different ways. To factory reset optiPoint 410/420 phones (CorNet IP) see Factory reset optiPoint 410/420 phones.
Contents
optiPoint 410/420 S (with display)
By Web-based management
(TBD)
By local phone procedure
Ensure that call control is on the phone, not the DSM ???.
- Disconnect phone from LAN.
- Lift handset.
- Type in reset code .
- Type in reset password .
- Replace handset.
- Connect phone to LAN.