Difference between revisions of "Collaboration with VoIP Providers"

Revision as of 09:06, 8 March 2017

You are here:

Home  Communications Systems  Collaboration with VoIP Providers

The connection of communication systems to the public network via SIP Trunking can be used instead of or in addition to traditional PSTN trunks. Many VoIP Providers, also known as ITSPs, are offering corresponding services. The following article gives an overview of the SIP trunking features and limitations and lists the Providers, which have been tested and released with the SME platform OpenScape Business.

You did not find your provider? Find out how to get it released!

Overview

OpenScape Business has been tested with a large number of Internet telephony providers that support SIP. Continuously new providers are tested, released and included within administration. As the SIP recommendations leave some room for interpretation, there are differences in the range of features supported with a specific provider. In this chapter general information is given which is valid for all SIP Providers.

SIP trunking features

• Up to 8 active SIP providers and one Internet connection
• Operation behind another router using STUN (can be configured per provider with current software) - integrated SBC functionality
• SIP trunking with single numbers (MSN) and up to 30 SIP user accounts (called Internet telephony stations in WBM)
• Direct Inward Dialing (DID)
• Comprehensive feature set available e.g.
  • CLIP
  • Hold, Consultation, Toggle
  • Transfer (attended, semi-attended)
  • Ringing group, Call pickup
  • Conference
  • Call Forwarding
  • DTMF transmission e.g. for voicemail access
• Simultaneous VoIP connections depending on system and available DSL bandwidth, used Codec and system. G.711 needs up to 92 kbit/s, G.729A needs up to 36 kbit/s in both directions.
• Automatic fallback to ISDN at SIP trunk failure
• Voice Codecs G.711 and G.729
• Fax over IP via T.38

General Requirements for VoIP

• LAN with 10/100/1000 MBit/s and no more than 40% network load
• Separate port on the switch or router for every component in the IP network (no hubs as concentrators)
• Not more than 50 ms delay in one direction (One Way Delay); not more than 150 ms total delay
• Not more than 3% packet loss and 20 ms jitter
• Quality of Service (QoS) support - IEEE 802.p, DiffServ (RFC 2474) or ToS (RFC 791)
• Sufficient WAN bandwidth (uplink and downlink) for intended simultaneous calls and CODEC
• External modem or router
• Intermediate routers shall support quality of service and bandwidth control mechanisms if the WAN link is used for voice and data simultaneously. SIP messages have to be routed transparently.

For interworking with different network configurations and edge devices and how to use STUN please see Network Configuration for VoIP Providers.

Hints for all Providers

• Special call numbers and emergency calls may need alternate TDM connections
  • Special call numbers (e.g. 0800, 0900, 0137) are not supported by all SIP providers
  • analog fax/modem connections are not supported by all SIP providers.
  • Emergency call numbers (e.g. 110, 112) are not supported by all providers.
• Concurrent calls via ITSP (depending on the available bandwidth and used Codec).
  • 30 for OpenScape Business X1
  • 60 for OpenScape Business X3 / X5 / X8
  • 180 for OpenScape Business S
• DTMF transmission
  • outband transport via RFC 2833/RFC4733 is highly recommended. The ITSP MUST support outband DTMF (RFC2833/RFC4733) if UC Suite functions via SIP trunk (e.g. auto attendant, voicemail control) shall be used.
  • inband transport may be used, but the functionality cannot be guaranteed as endpoints (e.g. UC-Suite) may not support inband DTMF.
• FAX over IP with T.38 is recommended for analog Fax devices, terminal adapters and the OpenScape Business UC Suite.
  • If your provider does not support Fax T.38, Fax pass-through with G.711 is possible but transmission quality depends on network infrastructure in this case.
  • Since OpenScape Business V2 UC Suite is able to handle T.38 to G.711 fax fallback as well.
• CLIP no screening (set a different number to be displayed at called party) is available with ITSPs in DID mode. More details in "OSBiz V1/V2 Configuration for ITSP".
• In a network, a configured ITSP can be used at each respective node. From OpenScape Business V1R3 one centralized ITSP in a network can be used.(with ITSP in DID mode)
• An incoming ITSP call can be transferred or forwarded to another public subscriber via ITSP. 2 lines (one incoming and one outgoing) are used while the call is active.
• A trunk prefix to select a SIP trunk as an alternate trunk can be used from the OpenScape Business client's dial box but not from client's directories and settings (myPortal, myAttendant, myAgent).
• SIP trunks cannot be used for presence based call forwarding, if a TDM trunk is also present because of the limitation above.

How to get a new VoIP provider released

Tests are necessary with every new provider before making installations in the field due to different implementations of the SIP protocol. Otherwise no support is available for an ITSP. Test resources have to be provided by the region or partner.

1. Select the VOIP / SIP trunking providers, which are most important for your business, estimate business relevance and get agreement for start of certification from product management.
2. Download   VOIP provider data collection and test list - last update: 2017-02-24
   Follow the instructions listed in the "VoIP Provider Data Collection" document and send the profile to the VoIP Provider certification team. This is essential for correct PBX setup.
3. Perform all tests in the VoIP provider test list when the PBX setup has been verified and approved by the VoIP Provider certification team. System configuration and tests require trained local personal. Remote support is available by the VoIP Provider certification team.
4. Deliver the test results, including all Wireshark traces and final provider data to the VoIP Provider certification team.
5. Prepare a Provider specific configuration guide, which will be published on this wiki page later on. An example-doc is included in the ZIP-file. Use English screenshots from OpenScape Business please. Explanations can be added in your language. e.g. German Provider in German language, French Provider in French language, International provider in English language... Deliver the document to the VoIP Provider certification team.

After successful tests the VoIP provider will be released and published on this page. Regular back level support is available for issues with the new provider after that. A preconfigured VoIP provider profile will be included in the OpenScape Business administration for easy setup.

General Configuration guides

  OSBiz V1 Configuration for ITSP- latest update: 2014-12-17

  OSBiz V2 Configuration for ITSP- latest update: 2016-01-15

  HowTo-CLIPnoScreeningEng- latest update: 2015-10-26

  HowTo-CLIPnoScreeningDeu- latest update: 2015-11-04

Tested VoIP Providers by Countries

The main SIP trunking functions of the SME platforms have been tested with the following Internet telephony providers. For detailed information see the document Overview about Released SIP Providers below.

International

VoIP Providers	Configuration Guide
COLT	-
Verizon	AppNote OpenScape_Business_V1 with_Verizon_IP_Trunks ML 10052013 V05
Skype Connect	-

• Please check provider home page for supported countries.
  
• Skype Connect is a fee-based business service from Skype. It allows voice communication between Skype clients and office phones using the standard SIP trunking interface. Other Skype client features like chat or video are currently not supported.

Our SME Platforms have been officially certified by Skype.   Skype Connect with SME platforms

Australia

Austria

Belgium

Brazil

Canada

Chile

Czech Republic

Denmark

VoIP Providers	Configuration Guide
Global Connect	-
TDC	TDC Denmark latest update: 2017-02-10
Uni-tel A/S	-

Finland

France

Germany

VoIP Providers	Configuration Guide
1&1	-
ecotel sipTrunk DDI	-
ecotel sipTrunk Connect 1.0	-
ecotel sipTrunk 2.0	Ecotel_SipTrunk2.0_Germany latest update: 2017-01-11
ennit AG(formerly tng)	-
Equada	-
GMX (now 1&1)	-
HFO	-
M-Net	-
MK Netzdienste	-
Peoplefone AG	-
Purtel	-
QSC IPfonie extended (DID)	-
QSC IPfonie extended Connect (DID)	-
sipgate basic (MSN)	-
sipgate trunking (DID)	-
Deutsche Telekom IP-As mit MSN	Deutsche Telekom DIPVD latest update: 2016-06-03
Deutsche Telekom DeutschlandLAN SIP-Trunk	Deutsche Telekom ALL-IP SIP-Trunk latest update: 2016-09-07
toplink	-
Vodafone (formerly Arcor)	-
Anlagenanschluss R3 (DID)	Vodafone IP-ALA-R3 Germany latest update: 2016-11-04

Greece

VoIP Providers	Configuration Guide
CosMote	COSMOTE Greece latest update: 2016-10-02

Italy

Lichtenstein

VoIP Providers	Configuration Guide
/ FL1 Telekom	FL1 Liechtenstein latest update: 2016-04-14

Mexico

The Netherlands

VoIP Providers	Configuration Guide
BCOM	BCOM Netherlands latest update: 2016-03-21
BLU	OpenScape Business V2 Config ITSP BLU telecom latest update: 2016-05-02
Deanconnect B.V.	-
Infopact	-
KPN	KPN Netherlands latest update: 2017-02-10
Motto Communications	-
OneCentral	-
OneXS	-
Priority Telecom	-
RoutIT	-
SIGNET B.V.	SIGNET telecom Netherlands latest update: 2016-09-30
Speakup	-
Tele2	-
T-Mobile NL	-
Vodafone NL	-
Voiceworks	-
X2COM	X2COM Netherlands latest update: 2016-06-03
Ziggo	-

New Zealand

Portugal

Serbia

Slovakia

Slovenia

South Africa

Spain

VoIP Providers	Configuration Guide
LCR (Least Cost Routing)	-
Telecable	-
vozelia	-
VozTelecom	VozTelecom_Spain latest update: 2016-08-07
Xtra Telecom	-

Sweden

Switzerland

VoIP Providers	Configuration Guide
Cablecom	-
efon	-
Peoplefone AG	-
sipcall	-
Sunrise	Sunrise_SIP-Trunk_Swiss latest update: 2017-01-11
Swisscom BCON	-
Swisscom Smart Business Communication	-
Swisscom VoIP Gate	-
Swisscom Enterprise SIP	-
Telco Pack SA	-
vtx	-

United Kingdom

VoIP Providers	Configuration Guide
BT IPVS	-
Gamma	-
HIPCOM	-
KCOM	KCOM UK ITSP SIP Trunk Configuration latest update: 2016-06-03
Opal	-
TalkTalk	-
tIPicall	-
Voiceflex	-
VoIP Ltd i-Line	-

United States of America

VoIP Providers	Configuration Guide
AT&T	OSO_ATT SipTrk Configuration Note 07092013 V1
Cbeyond	-
CenturyLink	-
Intermedia	-
Sotel	-
Windstream   (Broadsoft platform only)	-
XO	-

Released SIP Providers in Detail

The table above shows the ITSPs that passed successfully a connectivity test. More details about test results, supported features and restrictions for a specific ITSP are listed in following PDF document.

  Overview about Released SIP Providers Latest update: 2017-02-28

The following scenarios are covered within the connectivity test:

• Registration
• Basic Calls from / to ITSP
• Feature Tests
  • Consultation, transfer, toggle, conference
  • Call Pickup / ringing group scenarios
  • call forwarding scenarios
  • DTMF
  • CLIP / CLIR
  • COLP / COLR
  • FAX
• Special Tests
  • emergency calls
  • service calls
  • long duration calls
• Calls handled via UC application

The connectivity tests are performed using various endpoints (for details see test list).

Frequently asked Questions

• VoIP Provider FAQ - answers to frequently asked questions

Information for discontinued platforms

For discontinued platforms see Collaboration with VoIP Providers (discontinued platforms).

External Links

• Partner Portal (login required, Internet Explorer only)
•   VoIP Anbieter (Übersicht, Feature, Vergleiche)