The optiPoint 150 S Release Notes describe descending sorted new features, fixed firmware bugs und open issues for appropriate firmware versions of the optiPoint 150 S (
optiPoint 150 S).
V1.26
What’s New?
Fixed Bugs
| Internal ID
|
Cluster
|
Problem
|
Comment
|
| 400
|
HP3k
|
No Ringback tone when calling Upoe or HFA phone @ HP3k
|
complies now to RFC 3960 sect 3.2
|
| 392
|
Admin
|
Possible to configure Call forwarding at the phone when connected to HP3k, HP4k)
|
Now neither WBM nor local admin can configure CF in this case (correct!)
|
| N/A
|
IP
|
Phone is sending out ARP requests for IP: 192.1.1.49 But this IP is NOWHERE configured in the phone.
|
|
V1.25
Fixed Bugs
- General: Possibiliy to use special characters in SIP-ID like (@, /, %) needed for registration on some of the SIP providers.
V1.24
What’s New?
- Support of DNS query SRV (DNS_SRV)
- Support DNS TTL
- Support RFC 3264 Hold for Broadsoft
Fixed Bugs
- General: alphanumeric SIP_ID’s now possible (e.g. vorname.nachname@provider.com)
- General: Loud tone when call disconnected
- General: Calltransfer not possible after toggle between calls
- LAN: phone doesn’t register, if L2 QoS value is set
- LAN: VLAN ID can’t be reset to None
- HiPath 3000: Toggle between calls not possible
- HiPath 3000: Busy tone after attended Call transfer
- HiPath 3000: HP3k-HP3k trunking, no payload after transfer
- Phone GUI: Remove possibility to configure Call Forwarding when connected to HiPath 2000, HiPath 3000, HiPath 4000, HiPath 5000
Known & Open Issues
- HiPath 3000: Blind (semi-attended) transfer doesn’t work
- Not possible to dial, after first call was made with Hook on
- Symmetric use of UDP ports (planned for V1.25)
V1.23
What’s New?
- Telnet port disabled
- Distinctive Ringing (Sylantro) supported
optiPoint 150 S).
