Difference between revisions of "optiPoint 150 S Release Notes"
The Wiki of Unify contains information on clients and devices, communications systems and unified communications. - Unify GmbH & Co. KG is a Trademark Licensee of Siemens AG.
Gunnar.boll (talk | contribs) (→Fixed Bugs) |
Gunnar.boll (talk | contribs) (→What’s New?) |
||
Line 4: | Line 4: | ||
=== What’s New? === | === What’s New? === | ||
− | * IP: New | + | * IP: |
+ | {| {{DefaultTable}} | ||
+ | ! Internal ID | ||
+ | ! Cluster | ||
+ | ! New feature | ||
+ | ! Comment | ||
+ | |- | ||
+ | | 398 | ||
+ | | IP | ||
+ | | New default QoS L3 values | ||
+ | | Signalling: AF31 (DSCP 26) and RTP: EF (DSCP 46) | ||
+ | |- | ||
+ | |} | ||
=== Fixed Bugs === | === Fixed Bugs === |
Revision as of 17:35, 2 September 2006
The optiPoint 150 S Release Notes describe descending sorted new features, fixed firmware bugs und open issues for appropriate firmware versions of the optiPoint 150 S ( optiPoint 150 S).
Contents
V1.26
What’s New?
- IP:
Internal ID | Cluster | New feature | Comment |
---|---|---|---|
398 | IP | New default QoS L3 values | Signalling: AF31 (DSCP 26) and RTP: EF (DSCP 46) |
Fixed Bugs
Internal ID | Cluster | Problem | Comment |
---|---|---|---|
400 | HP3k | No Ringback tone when calling Upoe or HFA phone @ HP3k | complies now to RFC 3960 sect 3.2 |
392 | Admin | Possible to configure Call forwarding at the phone when connected to HP3k, HP4k) | Now neither WBM nor local admin can configure CF in this case (correct!) |
N/A | IP | Phone is sending out ARP requests for IP: 192.1.1.49 But this IP is NOWHERE configured in the phone. |
V1.25
Fixed Bugs
- General: Possibiliy to use special characters in SIP-ID like (@, /, %) needed for registration on some of the SIP providers.
V1.24
What’s New?
- Support of DNS query SRV (DNS_SRV)
- Support DNS TTL
- Support RFC 3264 Hold for Broadsoft
Fixed Bugs
- General: alphanumeric SIP_ID’s now possible (e.g. vorname.nachname@provider.com)
- General: Loud tone when call disconnected
- General: Calltransfer not possible after toggle between calls
- LAN: phone doesn’t register, if L2 QoS value is set
- LAN: VLAN ID can’t be reset to None
- HiPath 3000: Toggle between calls not possible
- HiPath 3000: Busy tone after attended Call transfer
- HiPath 3000: HP3k-HP3k trunking, no payload after transfer
- Phone GUI: Remove possibility to configure Call Forwarding when connected to HiPath 2000, HiPath 3000, HiPath 4000, HiPath 5000
Known & Open Issues
- HiPath 3000: Blind (semi-attended) transfer doesn’t work
- Not possible to dial, after first call was made with Hook on
- Symmetric use of UDP ports (planned for V1.25)
V1.23
What’s New?
- Telnet port disabled
- Distinctive Ringing (Sylantro) supported