Difference between revisions of "optiPoint 150 S Release Notes"
The Wiki of Unify contains information on clients and devices, communications systems and unified communications. - Unify GmbH & Co. KG is a Trademark Licensee of Siemens AG.
Gunnar.boll (talk | contribs) (→Fixed Bugs) |
Gunnar.boll (talk | contribs) (→Fixed Bugs) |
||
Line 26: | Line 26: | ||
| N/A | | N/A | ||
| IP | | IP | ||
− | | Phone is sending out ARP requests for IP: 192.1.1.49 | + | | Phone is sending out ARP requests for IP: 192.1.1.49 But this IP is NOWHERE configured in the phone. |
− | But this IP is NOWHERE configured in the phone | ||
| | | | ||
|- | |- |
Revision as of 17:31, 2 September 2006
The optiPoint 150 S Release Notes describe descending sorted new features, fixed firmware bugs und open issues for appropriate firmware versions of the optiPoint 150 S ( optiPoint 150 S).
Contents
V1.26
What’s New?
- IP: New L3-QoS default parameters: Signalling: AF31 (DSCP 26) and RTP: EF (DSCP 46)
Fixed Bugs
Internal ID | Cluster | Problem | Comment |
---|---|---|---|
400 | HP3k | No Ringback tone when calling Upoe or HFA phone @ HP3k | complies now to RFC 3960 sect 3.2 |
392 | Admin | Possible to configure Call forwarding at the phone when connected to HP3k, HP4k) | Now neither WBM nor local admin can configure CF in this case (correct!) |
N/A | IP | Phone is sending out ARP requests for IP: 192.1.1.49 But this IP is NOWHERE configured in the phone. |
V1.25
Fixed Bugs
- General: Possibiliy to use special characters in SIP-ID like (@, /, %) needed for registration on some of the SIP providers.
V1.24
What’s New?
- Support of DNS query SRV (DNS_SRV)
- Support DNS TTL
- Support RFC 3264 Hold for Broadsoft
Fixed Bugs
- General: alphanumeric SIP_ID’s now possible (e.g. vorname.nachname@provider.com)
- General: Loud tone when call disconnected
- General: Calltransfer not possible after toggle between calls
- LAN: phone doesn’t register, if L2 QoS value is set
- LAN: VLAN ID can’t be reset to None
- HiPath 3000: Toggle between calls not possible
- HiPath 3000: Busy tone after attended Call transfer
- HiPath 3000: HP3k-HP3k trunking, no payload after transfer
- Phone GUI: Remove possibility to configure Call Forwarding when connected to HiPath 2000, HiPath 3000, HiPath 4000, HiPath 5000
Known & Open Issues
- HiPath 3000: Blind (semi-attended) transfer doesn’t work
- Not possible to dial, after first call was made with Hook on
- Symmetric use of UDP ports (planned for V1.25)
V1.23
What’s New?
- Telnet port disabled
- Distinctive Ringing (Sylantro) supported