Difference between revisions of "optiPoint 410/420 V5.1 information"

Revision as of 19:04, 26 October 2006

Important information

General Info for all Version

• G.722 is used with DMC between two optiPoint 410 IP Phones only. (Feature DMC must be activated)
• A call via Gateway never uses G.722.
• If “High Quality pref.” is entered, G.722 calls to other OP410 are possible, but only G.711 calls to other phones (OP600 and OP400). Because of this the users get a different impression of quality.
• It is highly recommended to switch off VAD/ Silence suppression.
• To upgrade via Netboot the key 3 have to be pressed while powering up the phone until the phone starts to load the image.
• DTMF Tones not working when connected to HiPath 3000 V6.0. For this gateway problem a workaround is available by change of the configuration of the HG1500 via Explorer  Sprachgateway  Codec Parameter  Übertragung von DTMF Tönen nach RFC2833 to OFF.
• Netboot Upgrade via Remote is only possible with V5R1.33.000 or later

since Version V5 R1.33.0 or later

• IMPORTANT!! At the moment there is a Prio 1 Bug at the DLS in combination with the NEW Version string.
  At the Software Deployment in the DLS you can’t update more than one Phone at the same time.
• IMPORTANT!! It is REQUIRED! to update to Version V5R1.33.000 for every version ≤ 5.1.32.
  If this is not done no upgrade will be possible anymore because of the Version string changes, Security Check in the phone software.

  Example:

Update from 5.1.30 to V5R1.33.000 is possible

Update from 5.1.30 to V5R1.34.000 is NOT possible

Update from V5R1.33.000 to V5R1.35.000 is possible

since Version [[optiPoint 410/420 Release Note#V5 R1.34.0|V5 R1.34.0 or later

• Now the Software comprised the AGP functionality including XML Application Support.
  This functionality will be only released project specific for prototype of corresponding applications.
  The AGP Feature works only with a APM Module connected.